E
17
item 01 902
5. The "Danger" symbol is displayed with beep audible alert if the
alcohol concentration is the level:
= > 0,050% BAC or 0,0500‰, or 0,250 mg/l.
6. Unit conversion: under the test result mode, hold down the
"Power" button to change the units (%BAC / ‰BAC / mg/l), the
final displayed units will be the units for the next test.
7. If no blow into the breath inhaler at the test mode, the LCD will
display "0.000 %BAC "or "0.000 ‰BAC" or "0.000 mg/l" value.
Note To obtain more accurate result, manufacturer recommend you
to check repeatedly 2 or 3 times.
Auto power off
Test results will display about 20 seconds on the LCD, and then the
tester will automatically switch off.
Replace battery
LCD screen flashes for low power, please replace the alkaline batte-
ries.
How to use the clock
1. Press and hold <SET> button for 2 seconds to enter real time
hour setting, the hour digit is flashed on the clock LCD, press
< > button to adjust.
2. Press <SET> button again to enter minute setting, the minute
digit is flashed, press < > button to adjust.
3. Press <SET> button to confirm.
To Next Page
Loading...
