3.5 Synchronising the Thermostat and the
Receiver Unit
In order to have a safe, reliable and trouble-free wireless
(radio-frequency) connection, both the thermostat and the
receiver unit have their own safety codes. After installing
the receiver unit, the two units should be synchronised
by pressing the “LEARN” button
located on the main panel of the
thermostat. Therefore do not
replace the rear panel of the
thermostat onto the front panel
before synchronisation. The
process of synchronisation is
described in Chapter 7.2.
4. OPERATION OF THE INSTALLED
THERMOSTAT
The thermostat controls the device connected to it (e.g. gas
boiler or pump) based on the temperature measured by it and
- 13 -
To Next Page
Loading...
