Computherm Q7RF - Page 47

- 47 -
A BRIEF DESCRIPTION OF PROGRAMMING
• Setting the date and time: press the “DAY” button, then adjust values
using the “DAY”, and buttons.
• Programming: press and hold down the “SET” button, while pressing
the “PROG” button too, then adjust values with the “PROG”, and
buttons; use the “COPY” button to copy repeated programmes.
• Program inspection: using the “PROG”, and buttons.
• Retuning: using the “M/A”, “SET” and “DAY” buttons (see Chapter 10.2).
• Transmission distance control: press the “TEST” button for more
than 3 seconds.
• Temporary modication of the temperature set in the program:
- until the next switch in the program: set the temperature using the
and buttons.
- for a period of 1 to 99 hours: set the temperature using the
and buttons, then press the “DAY” button, and nally set the
duration using the and buttons.
- for a period of 1 to 99 days: set the temperature using the
and buttons, then press the “HOLD” button and hold it down
for 2 seconds, and nally set the duration using the and
buttons.
- until the next interference: set the temperature using the
and buttons, then press the “HOLD” button briey.
- 47 -