Comunello R-CONTROL - DIP-SWITCH 3: Deleting Stored Transmitters

To Next Page

To Previous Page

ENGLISH

E Within 5 seconds press and hold for 5 seconds the key PROG of the transmitter 2 to be programmed.

F Set the transmitter dip-switch no. 1 of transmitters 1 and 2 into OFF position.

G Wait 10 seconds.

H Pressing the keys

UP or DOWN the actuator moves in opening/closing direction.

5.7 DIP-SWITCH 3: DELETION OF ALL THE STORED TRANSMITTERS

To delete all the transmitters stored on the control unit it is necessary using a remote control previously stored and

proceed as follows:

A Power only the control unit to be reset.

B R6-CONTROL only: press the key SELC on the transmitter repeatedly until displayed the channel stored (by the

leds).

C Set the transmitter dip-switch no.3 into ON position.

D Press and hold for at least 10 seconds the key PROG of the transmitter.

E Leave the key PROG and set the remote dip-switch no.3 into OFF position.

E Release t

he key PROG and set on OFF the transmitter dip-switch no.3.