FAQs
9.Q: Is the camera always recording in loop mode? How
can I turn off the mode?
A: Yes, it's defaulted to loop recording, and you can set
“no” for loop recording in the SETTIME.TXT file to turn
off the mode.
10.Q: Why I can't playback the video on the computer?
A: If you use Mac, please try VLC player. If you use
windows computer, please try KM player. Sometimes,
it is the problem of the media player.
11.Q: Why my video has no audio?
A: Please check that the audio on button is turn on or not
when you recording. If yes and still no audio, please
change the media play and try it again.
12.Q: Why the battery cannot last so long as said 2 years
standby time?
A: standby time means there is no motion to be recorded;
it can last 2 years when you fully charged the camera.
13.Q: How to install or remove the SD card?
A: Push the card that clip down into the slot until you hear a
click to install. Then Use your finger nail or the pin
(included) to push the card a little bit under the surface,
the card will pop itself out
19
To Next Page
Loading...
