1. Turning the Camera On/Off
Using the ribbon to take off the frame front cover first.
(1) Press and hold the power to switch the camera on.
The LED will light up blue, which indicates that it is in
standby mode.
(2) Press and hold the power to switch the camera off.
The LED will flash alternating red and blue and then
turn off.
ON lights up blue and
the camera is in standby
mode
OFF flashes alternating
red and blue and then t
urns off
Note: If the camera switches off automatically, there
are two reasons:
1. The battery power is too low and the camera must be
charged.
2. The camera has been in standby mode without any
operation for longer than 1 minute. In this case, the
camera switches off to save battery power.
2. How to Record A Video
(1) PIR motion detection video record
Press MD button to enter 1 minute test recording. The
Blue and Red LED indicator will flash and then go off,
The Red LED indicator stays on .
2S
How to Use Your Conbrov T10 camera
12
To Next Page
Loading...