concept 2 SkiErg - Assembly And Installation Manual

CONCEPT2.COM
Page 1 0815
(1) universal bracket
(1) T27 6-lobe driver
Located in SkiErg box
Floor Stand Assembly and SkiErg Installation
With the wooden base
on its side, position
the universal bracket
on the base as shown.
1
Assemble a fastener
and washer and insert
through the top of the
wooden base and into
the universal bracket
in one of the outside
holes. The fastener
will protrude from
the underside of the
wooden base.
2
Install a T-nut over the
protruding fastener and
finger tighten. Use a
hammer to fully seat the
T-nut on the fastener.
Repeat steps 2 and 3
on the opposite outside
hole and tighten both
fasteners.
3
From the underside of
the wooden base, insert
the two remaining
T-nuts in each of the
two inside holes of
the universal bracket.
Use a hammer to fully
seat the T-nuts. Lay the
wooden base on its
bottom in preparation
for mounting the
SkiErg.
4
U-bar bracket
U-bar
Wooden
Base
Parts Bag Contents
(8) 1 1/4” fasteners
PN 2206
(4) T-nuts
PN 2251
(8) black washers
PN 1259
(6) 1/2” fasteners
PN 1231
(1) 1 1/4” fastener
PN 2206
(1) black washer
PN 1259
(2) T-nuts
PN 2251
(2) T-nuts
PN 2251