59
LA6983bc
EN
Setting the Temperature of the Variable Zone
• Press and hold the sensor button (A) for 3 seconds to unlock the control panel.
• Press the appropriate sensor button (A) to set the temperature in the variable zone by 1 °C.
• The temperature of the variable zone can be set between 3 °C to -2 °C.
• If you set the temperature from 3 °C to 1 °C, you will create such conditions in the variable zone as in the refrigerator.
• Setting the 0 °C temperature will produce a zero zone.
• If you set the temperature from -1 °C to -2 °C, you will create such conditions in the variable zone as in the freezer.
INSTALLATION OF THE APPLIANCE
• Defects caused by improper installation are not covered by the warranty.
• Installation is the responsibility of the customer not the manufacturer.
• The manufacturer bears no responsibility for damage caused to people, animals or property due to incorrect
installation.
• Place the appliance on a flat place in a well-ventilated are.
• Do not place the appliance under the direct sun shine.
• The appliance should be placed at least 10 cm from the wall at the back and both sides. There should be a free space
of approximately 30 cm above the appliance as it needs to ventilate freely.
• If necessary, use the adjustable feet at the bottom of the appliance to align the appliance in a horizontally stable
position.
CONNECTION TO THE MAINS
• Make sure the mains voltage and current protection correspond to the values on the rating plate of the appliance.
We recommend using a separate outlet with a 10 A circuit breaker.
• Only use grounded sockets.
• Do not use multiple sockets, plugs and extension cords. There is a risk of overheating.
• The plug of the power cord on the appliance must be freely accessible even after the installation.
• Changes in a connection may only be performed by a qualified professional.
• Electrical safety of the appliance can be guaranteed only if the protective terminal of the appliance is connected to
the protective conductor of the mains.
• The manufacturer bears no responsibility for damage to persons or property as a result of missing or bad protective
connection.
• The power cord must be positioned in a way that it is not deformed or excessively bent.
CLEANING AND MAINTENANCE
• Disconnect the power cord from the wall outlet or switch off the circuit breaker of the appliance before cleaning
and maintenance.
• Dust and dirt on the appliance on the wall and on the ground should be regularly cleaned for trouble-free operation
and energy savings.
• The inside of the refrigerator should be cleaned according to the frequency of use to avoid unpleasant odours.
A
To Next Page
Loading...