Concept2 PM3 Getting Started

6
MISCELLANEOUS
Cleaning the PM
Use a cloth lightly dampened with water only. Do not spray with a cleaner or leave in the rain.
Formulas Used
Watts=2.80/(sec/meter)^3
Calories/Hour=Kcal/hr=(watts)x(4)x(0.8604)+300
Do not:
• Opentheplasticcase
• Dropthebatterypack
• Allowbatterypackpinstotoucheach
other or any metal object
• Useifdamagedorleaking
• Trash,incinerate,crush,etc.
Do:
• UseonlyinaPM4;ifnotusedinPM4,storecarefullysopinsarenotshorted
• Keepcleananddry
• Usebetween0˚and40˚C
• Charge(roworplugPM4intoUSB)afterprolongedperiodofnon-use
• Keepbatterypackawayfromchildren
• Recycleproperly
 WARNING:Ifbatteriesleak,donotusethem.Batteryuidsarecorrosiveandcandamageeyes,irritateskin,etc.If
contact occurs, wash affected area immediately and thoroughly with water.
Safety Information for PM4 Rechargeable Battery Pack
Port for the optional
Polar™ heart rate
receiver.
Bottom View of PM
Battery cover
PM3
Race system jacks
PM4
Back View of PM
Reset here
Flywheel sensor cable must be connected
here for the PM to operate.
USB port for connecting to a computer. Beveled
corners on USB cable plug face the back of the
monitor. DO NOT FORCE when plugging in.
Seeconcept2.com/pmfor current information.
TROUBLESHOOTING
1. If the PM malfunctions or does not “wake up,” try one of the following:
• Insertapaperclip(PM3)orpen/penciltip(PM4)intotheresetholeonthebackandpresslightly.
• Removethebatteriesfor30minutesandinserttwonewalkalineD-Cell(LR20)batteries.
2. To change language: press [MENU/BACK] until screen stops changing. Press fifth grey button on right, then press second
grey button on right twice, and select your language. Alternately, hold down CHANGE UNITS and CHANGE DISPLAY and reset
monitor. You can then select your desired language.
3. IfyourcomputerdoesnotrecognizethatyourPM3/PM4isconnectedtoittryoneofthefollowing:
• Useanothercomputerand/orUSBcable.
• Removebatteriesfor30minutesthenreinsertbatteriesandtryagain.
Refertoconcept2.com/pmformoreinformationandsoftwareupdates.
Battery compartment: Loosen screw and press
thumbstrike in direction shown to open.
PM3
PM4
Notes:
1) Remove batteries or battery pack from the PM3 or PM4
if monitor will not be used for a period of four months or
more.

Concept2 PM3 Specifications

General

Display	LCD
Backlight	No
Power Source	2 D cell batteries
Data Storage	Stores workout data
Connectivity	USB
Compatible With	Concept2 RowErg, SkiErg, and BikeErg
Workout Feedback	Pace, watts, stroke rate, Calories