6
Port for the optional Polar™
heart rate receiver.
MISCELLANEOUS
Cleaning the PM
Use a cloth lightly dampened with water only. Do not spray with a cleaner or leave in the rain.
Formulas Used
Watts = 2.80/(sec/meter)^3
Calories/Hour = Kcal/hr = (watts) x (4) x (0.8604) + 300
Troubleshooting
1. If the PM malfunctions or does not “wake up,” try one of the following:
• Insert a paper clip (PM3) or pen/pencil tip (PM4) into the reset hole on the back and press lightly. See below.
• Remove the batteries for 30 minutes and insert two new alkaline D-Cell (LR20) batteries.
2. To change language: press [MENU/BACK] until screen stops changing. Press fifth grey button on right, then press second
grey button on right twice, and select your language. Alternately, remove battery for 30 minutes and re-install battery. You
can then select your desired language.
3. To edit Custom List you must have a LogCard inserted. From Main Menu select More Options > LogCard > LogCard
Utilities > Edit Custom List. This enables you to copy workouts from Favorites on your LogCard to the Custom List on
the monitor.
Refer to concept2.com/pm for more info.
Do not:
• Open the plastic case
• Drop the battery pack
• Allow battery pack pins to touch each
other or any metal object
• Use if damaged or leaking
• Trash, incinerate, crush, etc.
Do:
• Use only in a PM4; if not used in PM4, store carefully so pins are not shorted
• Keep clean and dry
• Use between 0˚ and 40˚ C
• Charge (row or plug PM4 into USB) after prolonged period of non-use
• Keep battery pack away from children
• Recycle properly
WARNING: If batteries leak, do not use them. Battery fluids are corrosive and can damage eyes, irritate skin, etc. If
contact occurs, wash affected area immediately and thoroughly with water.
Safety Information for PM4 Rechargeable Battery Pack
Bottom View of PM
Battery cover
PM3
Reset here
Race system jacks
PM4
Back View of PM
Battery cover
Reset here
Flywheel sensor cable
must be connected here
for the PM to operate.
USB port for connecting to a computer.
Beveled corners on port face the back
of the monitor. DO NOT FORCE when
plugging in. See concept2.com/pm for
current information.
To Next Page
Loading...
Need help?
General