3.3.4. Alarm time setting
Click SYSTEM SET->> ALARM->>Schedule to access it.
Figure 20
The device will trigger the alarm only during the scheduled time period, you can select
the scheduled time according to your request. Example of figure 20, set armed time from
Mon 8:30 to 9:30, you only need to click the corresponding time block to set them, the
time block will become green when you selected.
Note: Please make sure your system time is correct before you set the alarm time period.
Please refer to chapter 3.5.2 to set system time.
3.4. Advance setting
3.4.1. User management
Click SYSTEM SET->>ADVANCED->>User to access it.
Figure 21
There are 3 levels of user authorization in it.
Administrator: “admin” has the highest authority. It can do any settings. The factory
default password: 123456.
User: user can only operate the device but can’t do any settings. The default
password is user.
Guest: User can view the video, but can’t operate the device. The default password
is guest.
Note: Please change these 3 level passwords when your first use to ensure your safety.
To Next Page
Loading...