Copyright
®
2008 by Conceptronic – All rights reserved
www.conceptronic.net
Page 5 of 7
2.6 As soon as the upgrade process is completed, the screen will go black.
Note: The device is still turned on. You need to manually turn off the device by pressing the
‘POWER’ button on the remote control. You can completely turn the device off by
turning off the switch on the back side of the device.
2.7 Remove the USB stick or memory card from the device.
Note: Never do this when the device is turned on and the upgrade process is busy. This will
result in an unusable product.
3. Checking the current firmware version
3.1 Make sure the CSM3PL is connected to a TV or monitor.
3.2 Press the “SETUP” button on the remote control.
3.3 Highlight the “FIRMWARE VERSION” option. The firmware version is displayed on the lower left
corner. This should be “CSM3PL_FW_VER_1.58D”.
3.4 If the displayed version isn’t the same as the version described at point 3.3, then you need to
repeat the upgrade procedure as described in chapter D.
To Next Page
Loading...
