Conceptronic Grab’n’GO CH3SNAS - Hardware Installation; Installing the Harddisk(s)

ENGLISH
23
3 Hardware Installation
3.1 Installing the Harddisk(s)
1) Slide the lock located on the bottom of the front panel to the right position, then
slide the front panel up and then pull it off the server to access the drive bays.
2) Insert 1 or 2 SATA 3.5” hard disk drives into the available drive bays until they are
firmly connected to the SATA slot on the server.
LOCK UNLOCK
3) To extract a hard drive push the HDD eject lever down
4) Replace the front panel onto the server then slide the lock on the bottom of the
front panel to the left position.
o
n