Condor ACTLUMUS User Manual

Copyright © 2022, Condor Instruments Ltda. 18
Professor Tulio Street Ascarelli, 290 - Vila Madalena, São Paulo, SP - Cep:05449-020
Guide and Manufacturer's Declaration - Electromagnetic Immunity
The device is intended for use in the electromagnetic environment specified below. It is advisable that the purchaser or user of the device ensures
that it is used in such an environment.
Immunity test
Test level IEC
60601-1-2
Compliance level
Electromagnetic environment - guide
Mobile or portable RF communication equipment should not be
used at smaller distances from any part of the device, including
cables, than the recommended separation distance calculated by
the equation applicable to the transmitter frequency.
Recommended separation distance
RF driven
IEC 61000-4-6
3 Vrms
150 kHz a 80 MHz
3 Vrms
d = 1.17 √P
Irradiated RF
IEC 61000-4-3
10 V/m
80 MHz a 2,7 GHz
10 V/m
d = 0,35 √P 80 MHz a 800 MHz
d = 0,70 √P 800 MHz a 2.5 GHz
Where P is the maximum declared level of transmitter output
power in Watts (W) according to the transmitter manufacturer and
d is the recommended separation distance in meters (m).
The field intensity from fixed RF transmitters, determined by an
electromagnetic survey of field
a
, is less than the compliance level
for each frequency range
Interference may occur in the vicinity of equipment marked with
the following symbol:
NOTE 1: At 80 MHz and 800 MHz, the highest frequency range is applicable.
NOTE 2: These guidelines may not apply to all situations. Electromagnetic propagation is affected by the absorption and reflection of structures, objects and
people.
a - The field intensity of fixed transmitters, such as base stations for radio phones (cellular /wireless), terrestrial mobile radios, amateur radio, broadcasting
broadcasts (AM and FM) and television, cannot, in theory, be accurately predicted. To evaluate the electromagnetic environment caused by fixed RF transmitters,
an electromagnetic inspection of the site should be carried out. If the field strength value at the location where the device is being used exceeds the applicable RF
compliance level mentioned above, the device should be checked for proper operation. If unusual performance is observed, additional measures may be required,
such as changing the position or installation location of the device.
b
- In the frequency range between 150 kHz and 80 MHz, the field intensity should be less than 10 V/m.

Condor ACTLUMUS Specifications

General

Brand	Condor
Model	ACTLUMUS
Category	Measuring Instruments
Language	English