CONDOR PIT-STOP / TRAILER-STOP TRAILER ADAPTOR KIT INSTRUCTION MANUAL
STOP! WARNING: READ THIS FIRST!
First Read and Understand the Instruction manual and product labels for important safety, set-up and troubleshooting information If you have problems setting up or using
the CondorTM Pit-Stop, contact customer service @ 1-630-497-1962 or contact us via e-mail @ www.condor-lift.com. CondorTM Pit-Stop is not intended for use by children.
Assembly Instructions: Remove all parts from shipping box. Check the parts below to make sure you have all the parts needed to assemble your CondorTM Pit-Stop
before beginning. In the unlikely event that you find a part damaged or missing, please call customer service @ #815-754-5418
.
Condor Pit-Stop Parts Packing list:
PICTURES OF PARTS
KEY QUANTITY PART DESCRIPTION
J 1 Trailer Bracket
K 2 Socket Shoulder Screw-3/8x3/8 Thread-5/16-18
O 2 Large Washer (Fender Washer 5/16 x 1.25)
P 2 Flat Head Socket Cap Screw 82i 5/16-18 X 2-1/2
Q 2 Lock Nut 5/16-18
R 1 Spade Head w/shoulder thumb Screw (5/16-18 x 1.0)
User Instructions:
R
Q
O
J
P
K
Step1: Attach parts K to the Condor Pit-Stop/Trailer-Stop cross bracket as
shown. (Torque parts K to 18 ft-lbs)
Step2: Attach part J to mounting platform first. Allow a minimum of 10.0" of
space on the mounting surface from the center of the trailer bracket J to the
locked end of the Condor Pit-Stop/Trailer-Stop. The Condor unit should
always be fully planted on the mounting platform when engaged into the
trailer bracket J. Place part J parallel to platform end using the
recommended dimension and drill holes for part P using a 5/16 drill bit.
Step3: Once the holes for part J are drilled, secure it using parts P, O and Q.
Run Part P through part J and through mounting platform. Once part P has
passed through the mounting platform, secure it with parts O and Q. Make
sure that parts O and Q are secured as shown. Torque Q to 18-24 ft-lbs.
Step4: As shown, place Condor unit into Trailer bracket by inserting parts K
into part J key way. Once parts K have entered the keyway of part K, slide
the Condor unit forward and in the direction of the keyway path. Unit must
slide in smoothly. If unit does not slide easily, use included washers under
parts K to increase clearance to compensate for floor flatness. Once unit is
locked into part J, proceed to use part R to secure and lock unit in place.
To Next Page
Need help?
General
