SUPPLEMENTAL CRADLE SETTING RECOMMENDATIONS
FOR THE CONDOR® PIT-STOP (PS-1500), TRAILER ONLY MODEL (SC-2000) &
CYCLE LOADER (CL-1000) USER INSTRUCTION MANUAL
STOP! WARNING: READ THIS FIRST!
First Read and Understand the Instruction manual and product labels for important safety, set-up and troubleshooting information. If you have problems setting up
or using the Condor® Pit-Stop, contact customer service @ 1-800-461-1344 or contact us via e-mail @ www.condor-lift.com. Condor® Motorcycle products are
not intended for use by children.
Cradle Setting Instructions
:
The guidelines provided are recommendations only. Cradle settings may differ due to tire manufacturing variations such as
tire lot differences and tire circumference variations between lots of same and different brand tires. Due to this, the
Standard Cradle Setting Parameters
supersede all guidelines provided.
Standard Cradle Setting Parameters
:
**The optimum setting for a specific tire would be the setting that allows the cradle
to tilt as far forward as possible without making contact with the unit itself (SC-2000/CL-1000)
or the unit’s mounting surface, or the ground (PS-1500).**
The Condor® Cradle Mechanism is designed so that for every tire/wheel size within the ranges specified a minimum of 2 cradle settings are suitable.
The 2
nd
optimum setting would be the setting forward from the optimum setting which is away from the entry directions of the unit. If less retention is
desired at any time due to too much sticking, the 2
nd
optimum setting may be more suitable. Racing tire settings for GP or low durometer tire compounds would be
the 5
th
and 6
th
(PS-1500). This allows for the least amount of sticking when using the PS-1500 free standing.
For bikes with very low fenders and or cowlings, a custom cradle may be purchased fitted to a specific tire size, so as not to make contact.
Cradle Setting Guidelines
:
Due to the numerous tire wheel combinations available, these guidelines will provide in a general manner the placements of the
most common sizes seen on the market. These setting are recommended guidelines, they are not specific guidelines. The
Standard Cradle Setting Parameters
should be followed to customize the setting for your particular vehicle.
Front / Rear Width-Diam 1st Opt. Setting 2nd Opt. Setting Optim ized Se tting
Front 80, 90 -21" 1 2
Front 100, 120 - 21" 1 1
Front 100 - 18" 2 3
Front 100 - 19" 2 2
120 -17" 3,4 5
130 -16" 2 3
140 - 17" 1 2
150 - 17" 1 1
Rear 150+ 1 1
To Next Page
Need help?
General
