&Dn DTR Option
&D0 Ignore an on-to-off transition of DTR.
&D1 Switch to on-line command mode without disconnection.
&D2 Normal DTR operations.
&D3 Modem re-initialized. &Y determines which profile is loaded.
&Fn Load Factory Configuration (Profile)
&Wn Store Current Configuration
&W0 Store the current configuration as profile 0.
&W1 Store the current configuration as profile 1
.
4.3 S-Register Definitions
ATS? Read Selected S-Register.
This command reads and displays the selected S-Register. An S-Register can be selected by using the ATSn
command.
Sr=n Set Register r to n
S0 Number of Rings to Auto-Answer
The number of rings the modem waits for before it auto answers.
Range: 0-255 (rings)
Default: 0 (Country dependent)
S6 Wait Time before Blind Dialing
The time to pause after off-hook before blind dialing.
Range: 2-255 (rings)
Default: 2 (Seconds, Country dependent)
S7 Wait Time before Carrier Detect
The time to wait for a carrier from the remote modem before hanging up.
Range: 1-255
Default: 50 (Seconds, Country dependent)
S8 Pause Time For Dial Delay
To Next Page