Conqueror FBC120 - Technical Specifications; Check

GARAGE DOOR OPERATOR USER’S MANUAL
4
3. Technical specifications
Tools required
 A ladder and Tape measure
 Electric drill and assorted drill bits
 Screwdriver
 Spanner / Wrench
 Multimeter / Test pen
 Hacksaw / Cutter
 Pliers / Hammer
Use a helper if possible to assist with the installation .
4. Check
After receiving the product, you should make an unpack-inspection, in which you should check
whether the product was damaged. If you have any problem please contact dealer.
Fig.1
Model FBC120 FBC180 FBC200 FBC220
Motor power 60 W 80 W 100 W 120 W
Lifting capacity 600 N 800 N 1000 N 1200 N
Max. door size 10 m
2
12 m
2
14 m
2
16 m
2
Power supply 220X(1 ± 10%)V AC 50-60Hz
Motor 24VDC
Ambient temperature -20 º C~+50 º C
Working humidity ≦ 90%
Courtesy light time 3 minutes
Radio frequency 433.92 MHz
Transmitter type Rolling code
Transmitter battery 27A 12V
Bulb 24V 5W
1.Powerhead (x1)
3. Shuttle&Manual release cord(x1)
2. Chain drive rail assembly (x1)
6. Door bracket (x1)
5. Header bracket (x1)
8. Straight arm (x1)
10. Screw / Screw cap / Pin and R pin
11. Transmitter (x2)
R pin
Pin
Screw(M8x16mm)
Screw cap(M8) Screw cap(M6)
7. L arm (x1)
Screw(M6x22mm) Screw(M8x55mm)
4. Powerhead
bracket (x3)
9. Angle iron (x1)