Conrad-Johnson ET3 Preamplifier Owner’s Manual
Remote Control
All operations of the ET3 can be controlled by the wireless remote
unit.
MUTE: Pressing the mute button will cause the main outputs to
mute and the level display to be zero. Pressing it again will restore
the last level setting. Pressing and holding the mute button for
more than three seconds will switch the ET3 into standby mode (all
tube circuitry switched off). Pressing the mute button when the unit
is in standby mode will switch it back on.
SELECTORS (PH/AUX, TUNER, CD, VIDEO, AUX2): You can
directly access any of these inputs by pressing the associated
button on the remote.
EPLS (EPL1, EPL2): Pressing the EPL buttons inserts the
associated processor in the signal path. Pressing the button again
will re-establish a direct connection to the selected source.
Pressing the EPL2 button selects the THEATER input, setting and
locking the level to unity gain.
LEVEL (+, -): Duplicates the function of the front panel <level up>,
<level down> controls.
BALANCE: The ET3 does not include balance adjustment. These
buttons on the remote control have no effect on the ET3.
To Next Page
Loading...