10
Maintenance
Cleaning
Always unplug the unit before cleaning.
The unit should be cleaned frequently both
inside and outside using water and a little
neutral detergent. Do not use boiling water,
harsh cleaning agents, acid, alkali or benzene
etc.
Water Pan Cleaning
Leaving The Unit Powered Off
If the unit will be switched off for a long time,
the unit should be unplugged, then clean the
unit thoroughly. Ensure that the door cannot
be fully closed (leave a suitable gap), and
place the unit in a well-ventilated area to
avoid any odor.
The water pan is located in the back of cabinet.
Its function is to collect and evaporate
the defrosted water. Usually it doesn’t need special
care, but if you find some water overflowing or odd smell
it may need to be checked and cleaned. Pull out
the power cord first. LIFT THE WATER PAN UP
A LITTLE, AND THEN PULL IT STRAIGHT OUT
CAREFULLY.
(Caution: make sure the discharge pipe is not too hot).
After cleaning, replace the water pan into the original
position, make sure the pipe is on top of the water pan
before you push it into original position.
To Next Page
Loading...