Need help?Do you have a question about the Consew P1541S-CC and is the answer not in the manual?
General| Stitch Type | Lockstitch |
|---|---|
| Needle System | DP x 17 |
| Lubrication | Automatic |
| Type | Industrial |
| Feed Mechanism | Walking Foot |
| Max Sewing Speed | 2500 SPM |
| Hook | Rotary Hook |
Introduces the machine's compound feed and special feeding mechanism for smooth operation and heavy material sewing.
Details the machine's key specifications including speed, stitch length, needle type, lubrication, and motor.
Provides step-by-step instructions for installing the sewing machine components, including oil reservoir and knee control.
Guides on installing the oil pot and its related parts into the oil reservoir assembly.
Explains how to adjust the belt tension by pressing the belt and checking for a 15mm slack.
Details the procedure for attaching the right and left belt covers to the machine head.
Covers lubrication for the face plate, machine body, and rotating hook, including daily checks and adjustments.
Guides on how to correctly install the needle into the needle bar, ensuring the long groove is oriented leftward.
Explains how to insert the bobbin into the hook body and pass the thread through the tension spring.
Describes the process of removing and installing the bobbin case, aligning it with the rotating hook shaft.
Details how to attach the winding guider to the machine head and insert the bobbin thread guider.
Outlines the steps for winding thread onto the bobbin, including adjusting the winding amount and ensuring smooth winding.
Provides the correct order for threading the machine's upper and lower threads as shown in the figure.
Explains how to adjust stitch length using the dial plate and how to use the reverse feed lever.
Details how to adjust the tension for both the needle thread and the bobbin thread using nuts and screws.
Covers adjusting the swing range and tension of the thread take-up spring.
Describes how to operate the presser foot lifter to raise and lower the presser foot.
Explains how to adjust the pressure of the presser foot by turning an adjusting screw.
Details precise adjustments for the timing and clearance between the needle and rotating hook.
Explains how to adjust the alternating amount of the presser foot and the lifting amount difference.
Lists recommended sewing speeds based on alternating amount and stitch length.
Provides common troubles, their possible causes, and recommended remedies for sewing issues.
Diagram and list of parts for the sewing machine's arm and bed assembly.
Diagram of the upper shaft and thread take-up mechanism components.
Diagram illustrating the various parts of the needle bar vibrating mechanism.
Diagram showing the components of the upper feed mechanism.
Diagram of the various feed mechanism components.
Diagram of the lower shaft mechanism and its associated parts.
Diagram of the thread tension and bobbin thread winder mechanism parts.
Diagram of the knee lifter mechanism and its components.
Diagram showing lubrication points and parts related to the lubrication system.
Diagram of various accessories included with the sewing machine.
To Next Page
