Consew 75T User Manual

MODEL 75T
Specifications subject to change without notice.
Specifications subject to change without notice.
©2015 Consew USA -0815
©2015 Consew USA -0815
INSTRUCTION
MANUAL
PARTS
MANUAL
ALL PURPOSE, PORTABLE, SINGLE THREAD, CHAINSTITCH, BLINDSTITCH MACHINE
SETUP and OPERATING
All photographs in this manual are additionally ©2015 - Ron Greenfield / Forest Litho Printing Co.
MODEL 75T
Speed, Max. (S.P.M.) 1000 *
1
Stitch Length, Max. 3 / s.p.i. (7mm)
2
Needle Style LWX 6T
Looper 471
5
Cylinder Diameter 1 / " (40 mm)
8
Work Space (Needle to Arm) 4" (100 mm)
Stitch Type 103
SPECIFICATIONS
APPLICATIONS
* Speed depends on materials, operation and thread
Perfect for sewing all weights of materials including synthetics, woolens,
cottons, fabrics and knits
1 to 1 non-skip stitches, typical operations include felling edge tapes, bottoms
of trousers, cuffs, wigging in sleeves, facings to canvas and knit goods,
turned-up bottoms of fully lined coats, padding collars and lapels, and
reinforcing trouser seats
2 to 1 skip stitch for hemming dresses, skirts, slacks, trousers, sportswear,
ladies coats, draperies, blouses and other articles
Suitable for felling operations requiring a skip stitch to simulate hand-stitching
2 to 1 skip stitch is recommended for synthetics and other lightweight materials
and 1 to 1 for heavier cotton, woolen and linen goods
Ideal for alteration rooms, tailors, clothing rentals, dry cleaners,
department stores, dressmakers and home use
Back Cover
Front Cover

Consew 75T Specifications

General

Brand	Consew
Model	75T
Category	Sewing Machine
Language	English

Summary

Setting Up the Consew 75T Machine

Machine Location and Clamping

Place machine on a firm table near its right front corner and attach using table clamp.

Thread Stand and Guide Pole Assembly

Insert thread guide stud and pole, adjust loop over thread spindle. Tighten screws.

Motor Controller Pedal Connection

Insert controller plug into terminal block and connect to wall outlet. Regulate speed with pedal.

Knee Lifter Assembly

Push sleeve onto shaft, align pin with groove. Adjust angle and tighten set screw.

Machine Lubrication

Daily Lubrication Regimen

Oil 6 indicated holes daily before work. Wipe machine to remove residual oil.

Threading the Consew 75T

Using Cone Thread

Place cone over plastic base on thread stand. Ensure correct thread path.

Using Spool Thread

Use spool thread upside down, wedge end in notch to prevent snagging.

Needle Threading Path

Follow thread path from overhead guide to needle. Ensure correct needle positioning.

Needles and Thread Selection

Replacing the Machine Needle

Starting to Sew: Inserting Work Piece

Thread Tension Adjustment

Regulating Stitch Length

Needle Penetration Adjustment

Removing Work from Machine

Skip-Stitching Device Operation

Side/Rear Cover and Internal Lubrication

Removing Side/Back Cover

Remove side/back cover by loosening thumb screws for access and lubrication.

Rear Cover Removal

Internal Lubrication Notes

Machine has grease inside; for excessive dryness, seek professional service.