Consew 75T - Setting Up the Consew 75 T Machine; Machine Location and Clamping; Thread Stand and Guide Pole Assembly; Motor Controller Pedal Connection

4
A. Location (Figs.1-2)
Place machine on a firm table, preferably near its right front corner.
Attach machine near edge of table using table clamp which is included
with the accessories. Table clamp is inserted into the groove in base in
either the front or on the right side, whichever works easiest.
Make sure machine is clamped tightly to keep it from moving when
you are using knee-lift.
See Figs. 1 and 2 for details of clamping.
1.Setting Up the 75T Machine for Work
Unpack machine from its shipping box, making certain that you
remove from box all component parts and accessories.
Open the box and find
accessories on top and
the 75T on the bottom
B. Thread Stand and
(Fig.3)
Thread Guide Pole.
First, find the Thread Guide Stud (3);
it is black and just above the motor
in the back. Then insert the Thread
Guide Pole (2) into the hole in it
and tighten the thread guide Clamp
Screw (4).
(Don’t let the Pole (2) go down
so far as to hit the motor.)
Adjust it so the
Thread Guide Loop (5) extends over the
thread spindle (6). The Thread Guide
Stud Set Screw (1) can be loosened to adjust
the vertical angle of the Thread Guide Pole,
and then tightened back up, but as long as the
Loop (5) is over the thread spindle (6), it’s OK.
Fig.1
Fig.2
From Front of 75T
From Right Side of 75T
5
C. Connecting the Motor Controller Pedal (Figs.4-5)
Insert three-hole plug on controller wiring into terminal block at right side of machine
and insert standard plug into wall outlet. Place controller on floor and regulate speed
of machine by stepping on of floor pedal.
D. Assembly of Knee Lifter (Fig.6)
Push sleeve (1) onto free end of shaft (2)
and allow pin (3) to enter L-shaped groove
in sleeve. If you need to adjust the angle of
knee lifter, loosen the set screw (4) and adjust
the knee lifter to a comfotable angle.
Then, tighten the set screw (4).
Knee
Lifter