Consew 75T - Table of Contents

2
Spool Pin
Thread Tensioner
Machine Arm
Front Thread
Guide
Needle
Looper
Feed Dog
Work Plate
Machine Base
Thread Guide
Hand Wheel
Needle
Penetration
Dial
Cylinder Bed
Knee Lifter
Front Groove
for seating of
Table Clamp
(There is also
a groove on
the right side
of machine for
table clamping
from that side.
Either will work)
MODEL 75T
3
SET UP
and
OPERATING
MANUAL
MODEL 75T
Specifications subject to change without notice.
©2015 Consew USA -0815
-- Overview Diagram of 75T
1. Setting up Machine for Work . . . 4
A. Location . . . . . . . 4
B. Installing Thread Stand 4
C. Connecting Motor Controller . . . . . . . 5
D. Assembly of Knee Lifter . . 5
E. Clear Acryllic Sheild . . . . . . . . . . . 6
2. Lubrication
(The Oil Access Ports) 7
3
4. Needles and Thread . 10
5. Replacing the Needle . . . . . . . . . . . . . . 10
6. Inserting the Work Piece and Starting to Sew . 11
7. Adjustment of Thread Tension . 12
8. Regulating Stitch Length 13
9. Adjustment of Needle Penetration . . . . . . . 14
10. Removal of the Work from the Machine . . . . 15
11. Skip Stitch Device . 16
k PARTS BOOK: Table of Contents . . . . . . 19
-- Specifications & Applications . . . . Back Cover
. . . . . . . . . . . 2
k
(This Page) Table of Contents . . . . . . . . . 3
. . . . . . .
. . . . . . . . . . .
. . . . . . . . . .
. . . . . . .
. . . . . . . .
. Threading Machine . . . . . . . . . . . . . . 8-9
. . . . . . . . . . . . .
. . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . . . .
12. Side/Back Cover
(Notes on Lubrication) . . . . . 17
13. Back Cover
(Notes on Lubrication) . . . . . . . . 18
Table of Contents
Section
Number Section Description
Page
Number