Contax G2 - Page 101

228
2 Load batteries in the Power Pack P-8.
@insert four type AA batteries in the battery case
according to the markings in it, and install the
battery case in the Power Pack main unit.
(Put the Power Pack in the jacket (case).
Insert the plug fitted to the tip of the
Power Pack cord into the socket of the
Adapter GP-1.
e It is advisable to protect the Power Pack under
your coat or jacket while you take pictures in a
cold region, so that the battery cells will be
maintained warm.
e When you change the batteries, do not mix
different types of batteries or used batteries
with new ones. Replace all the four batteries
with new ones of the same type at the same
time.
e When you are not going to use the Power Pack
for quite some time, take the batteries out of
the battery case to prevent leaks from them.
e To remove the connection cord, pull the plug
and not the cord in itself.
m Power Pack P-8 Specifications:
Power Source: Four 1.5V AA-size alkaline batteries or
four 1.2V AA-size Ni-Cd batteries. (Ordinary manganese
AA batteries do not furnish sufficient power and should
not be used.)
Composition: Power Pack main unit, battery case and
jacket (with strap)
Length of cord: 1.5 meters
m Battery Types and their Capacities:
(number of rolls of 24-exposure film that can be exposed
with new batteries; according to Contax testing
standard)
Four 1.5V alkaline batteries (AA-size) About 25
Four 1.2V Ni-Cd batteries (AA-size) About 10*
* When fully charged
e Specifications and design are subject to change
without notice.