Need help?Do you have a question about the Contax 167MT and is the answer not in the manual?
Step 1: Insert batteries into the camera.
Step 2: Activate the camera's main power switch.
Step 4: Load film correctly into the camera.
Step 5: Select single-frame or continuous drive mode.
Procedure for attaching a lens to the camera.
Procedure for removing a lens from the camera.
Camera is turned off and disconnected from power.
Camera is turned on for metering.
Measures light with emphasis on the center.
Step 1: Insert batteries into the camera.
Step 2: Activate the camera's main power switch.
Step 4: Load film correctly into the camera.
Step 5: Select single-frame or continuous drive mode.
Procedure for attaching a lens to the camera.
Procedure for removing a lens from the camera.
Camera is turned off and disconnected from power.
Camera is turned on for metering.
Measures light with emphasis on the center.
General| Focus | Manual |
|---|---|
| Shutter | Electronically controlled vertical-travel focal-plane shutter |
| Exposure Modes | Program, Aperture Priority, Shutter Priority, Manual |
| Metering | TTL center-weighted average |
| Flash Sync Speed | 1/125 sec |
| Type | SLR |
| Lens Mount | Contax/Yashica (C/Y) |
| Viewfinder | Eye-level pentaprism |
To Next Page
