Contax G2 - Basic Steps; Load the Batteries

20
DX DX
DE DE
” v4
Replace the batteries.
<Battery Check>
After the batteries are loaded, operate the
camera first, the battery voltage is normal if the
mark “ca” (battery warning mark) does not
appear in the display panel.
<Battery Replacement>
If the mark “ca” turns on in the display panel, it
is time to replace the batteries. Set the main
switch at “OFF”, open the battery compartment
cover and replace the batteries with new ones.
@ Though you can take picture even after the
mark "CH" has turned on, it is recommended
to replace the batteries as soon as possible.
Be careful because the mark “ TÆ ” will blink
or go out and the camera will no longer
operate if the battery capacity has dropped
below the effective limit.
@ Some batteries may tend to decrease their
voltage temporarily when they are loaded. You
need not worry about this because they
recover their performance when the power is
turned on. If the mark “ CA ” appears soon
after the new batteries are loaded, turn off the
main switch and then turn it on again. If the
mark "CH" goes out, you can use these
batteries.