Contax G2 - Focus Lock; When Using SAF (Single Auto Focus) Mode

212
e To remove dust and dirt on the lens, focusing
window and viewfinder, use an air blower or a
soft lens brush. If they are soiled with
fingerprints, wipe off lightly with lens tissue.
e To clean the camera exterior, wipe with a soft
cloth. Never use benzine, thinner or other
solvents.
e After taking pictures in a dusty place such as
at the seaside or on mountains, clean the
camera thoroughly. Salt air will cause
corrosion and sand and dust will adversely
affect the internal precision parts of the
camera.
@ Do not leave the camera in hot places (on an
ocean beach in summer, in a parked car under
direct sunlight, etc.) for a long time, because
the camera, film and batteries may be
adversely affected.
@ The lens and viewfinder may be clouded if the
camera is brought into a warm room from
outside where it is cold. This cloudiness will
disappear soon, but it is always advisable to
avoid sudden temperature changes because
water droplets will cause internal corrosion.
@ If you are going to use the camera for
important events such as an overseas trip
or wedding ceremony, be sure to test it
beforehand to make sure that it functions
properly. It is also advisable to bring spare
batteries with you.
@ Because the camera is a precision device, do
not give excessive shock such as by dropping,
etc.
Note on the Shutter Curtain:
The shutter curtain is made of a very thin
material. Never push it with your finger, or
touch or wipe it. When changing film, take care
that the film edge does not touch on.the shutter
curtain. When using an air blower, do not blow
air strongly on the curtain because it may be
damaged or deformed. Never use a
pressurized blower.