Contax T3 - Page 26

<Default Flash Setting>
The camera’s default flash setting (the flash mode set
whenever the camera is turned on) can be changed if desired.
This feature is convenient if you most frequently use the ” or
“ 4 ” modes.
BIMM
■
HU
1
MNMB
m
nuMMMW
■
■ T
r AUTO
> <g>
Flash mode button '
Blinking Blinking
© With the camera turned on, hold the flash mode button
depressed until the flash mode indicator “ h ® ° ” begins to
blink {about 2 sec).
® Once the indicator starts blinking, let go of the button, then
press it again to select the desired default flash mode.
® After selecting the desired default mode, release the button and
about 8 sec later, the flashing indicator will light steadily,
indicating that the new mode has been set.
• The mode will remain set when the shutter release button is depressed
halfway or when camera power is turned off.
30