CARE AND CLEANING
Care and Cleaning
The settings below are guidelines only. The exact setting will depend on several factors,
including your cookware and the amount you are cooking. Experiment with the cooktop to
find the settings that best suit you.
Everyday soiling on
glass (fingerprints,
marks, stains left by
food or non-sugary
spillovers on the
glass)
1. Switch the power to the
cooktop off.
2. Apply a cooktop cleaner while
the glass is still warm (but not
hot!)
3. Rinse and wipe dry with a
clean cloth or paper towel.
4. Switch the power to the cooker
back on.
·When the power to the cooktop
is switched off, there will be ‘no
hot surface’ indication but the
cooking zone may still be hot!
·Heavy-duty scourers, some
nylon scourers and
harsh/abrasive cleaning agents
may scratch the glass. Always
read the label to check if your
cleaner or scourer is suitable.
·Never leave cleaning residue on
the cooktop: the glass may
become stained.
Boilovers, melts,
and hot sugary
spills on the glass
Remove these immediately with a
fish slice, palette knife or razor
blade scraper suitable for
induction glass cooktops, but
beware of hot cooking zone
surfaces:
1. Switch the power to cooktop
off at the wall.
2. Hold the blade or utensil at a
30°angle and scrape the
soiling or spill to a cool area of
the cooktop.
3. Clean the soiling or spill up
with a dish cloth or paper
towel.
4. Follow steps 2 to 4 for
‘Everyday soiling on glass’
above.
·Remove stains left by melts and
sugary food or spillovers as soon
as possible. If left to cool on the
glass, they may be difficult to
remove or even permanently
damage the glass surface.
·Cut hazard: when the safety
cover is retracted, the blade in a
scraper is razor-sharp. Use with
extreme care and always store
safely and out of reach of
children.
Spillovers on the
touch control
2. Switch the power to the
cooktop off.
3. Soak up the spill.
4. Wipe the touch control area
with a clean damp sponge or
cloth.
·The cooktop may beep and turn
itself off, and the touch controls
may not function while there is
liquid on them. Make sure you
wipe the touch control area dry
before turning the cooktop back
on.
To Next Page
