To Next PageTo Next Page
Need help?Do you have a question about the Continental Girbau DL2X30CG Series and is the answer not in the manual?
General| Brand | Continental Girbau |
|---|---|
| Model | DL2X30CG Series |
| Category | Dryer |
| Type | Commercial |
| Control Type | Microprocessor |
| Drum Material | Stainless Steel |
| Phase | 1 or 3 |
| Capacity | 30 lb |
| Heat Source | Gas |
| Voltage | 240V |
Essential information to minimize risks of fire, explosion, damage, injury, or death.
Critical steps to take if you smell gas, including evacuation and contacting authorities.
Keep all safety devices in place to protect from injury.
Necessary for safety and proper operation; failure voids warranty.
Recommendations on leaving electrical power on and shutting off gas supply.
Location and reset procedure for the safety thermostat.
Step-by-step guide for removing the dryer from its crate and positioning it.
Ensures installation complies with national and local gas and electrical codes.
Specific minimum clearances for sides, back, front, and floor installation.
Essential ventilation for dryer operation, specifying opening size and location.
Specifies wire gauge, grounding, and circuit breaker requirements for electrical hookup.
Details on pipe size, thread, compound, and pressure testing for gas connections.
Warning regarding solvent vapors from dry cleaners and their effect on dryers.
Guidelines for planning and constructing vent systems to prevent restrictions and lint buildup.
Recommendations for smooth interior pipes, limited elbows, and optimal pipe length.
Procedures for passing pipes through walls and venting through roofs, including protection.
Restrictions against venting into chimneys or under buildings due to fire hazards.
Explains the spark ignition system, gas valve operation, and lockout procedures.
Procedure for adjusting the primary air shutter for optimal flame quality.
Steps to safely render the dryer inoperative by turning off gas and power.
Overview of the controller, displays, and indicator lights for drum operation.
Instructions for loading, coin deposit, temperature selection, and starting the dryer.
Behavior when the door is opened and how to extend running time.
Information on adjustable operating parameters like vend price, temperatures, and cool-down times.
Detailed list of seventeen programming steps and their default settings.
Steps to access the controller's programming mode using specific switches.
Instructions for changing settings, resetting registers, and saving revisions.
How to activate the feature that redistributes the load after cycle completion.
How to enable retaining the last temperature setting for the next cycle.
Cleaning the lint screen and checking for damage.
Cleaning lint from motor areas, screen compartment, and burner housing.
Checking belts, fasteners, cleaning panels, oiling hinges, inspecting gaskets.
Cleaning burner orifices, greasing bearings, inspecting exhaust ducts, checking nuts.
