Contour Design RollerMouse mobile - Pairing and Secondary Options; Restart Bluetooth pairing; Restore pairing with dongle; Reset wireless function to automatic pairing mode

7
1. Restart Bluetooth pairing:
Press button B. While continuing to hold B,
press and release button C two times, then
release button B.
2. Select Bluetooth-only connectivity:
Press button B. While continuing to hold B,
press and release button C three times, then
release button B.
3. Select dongle-only connectivity:
Press button B, while continuing to hold B,
press and release button D three times, then
release button B.
Pairing and Secondary Options
• When the device is plugged in through the USB cable, this connection overrides wireless connectivity.
• Please visit contourdesign.com/BT for further information regarding your Bluetooth connection.
• If Bluetooth- or dongle-only connectivity is activated, the RollerMouse Mobile will retain
connection when the device is powered off then powered back on again.
4. Restore pairing with dongle:
Unplug then re-plug the dongle to the unit
to enable pairing. Hold the device close
to dongle and press button B. While
continuing to hold B, press and release
button D two times, then release button B.
5. Reset wireless function to
automatic pairing mode:
Press button B. While continuing
to hold B, Press and release button
C, then release button B.