EasyManuals Logo

Control 4 C4-FPD120 User Manual

Control 4 C4-FPD120
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Minimum Load (without neutral)
Incandescent (Tungsten) 25W
Halogen 25W
Fluorescent* N/A
Compact Fluorescent (CFL)* N/A
LED* N/A
Environmental
Operational Temperature 32˚ F - 104˚ F (0˚ C - 40˚ C)
All load ratings are based on an ambient
temperature of 25˚ C.
Humidity 5% to 95% non-condensing
Storage -4˚ F - 158˚ F (-20˚ C - 70˚ C)
Miscellaneous
Control Communications ZigBee, IEEE 802.15.4, 2.4 GHz, 15-channel
spread spectrum radio
Wallbox Volume 5.75 cubic inches
Weight 0.12 lb. (0.05 kg)
Shipping Weight 0.18 lb. (0.08 kg)
*
NOTES:
(1) The maximum and minimum load requirements for fluorescent, CFL
and LED loads can vary greatly depending upon the specific fixture and/
or bulb being used. At higher wattages, these load types have significant
in-rush current which can trip the protection circuitry on the device. At
low wattages, some CFL and LED loads will not be able to completely
shut o.
(2) In both cases, the quality and performance of these load types varies
greatly from manufacturer to manufacturer. When using these load types,
we recommend testing in advance. If problems are found, simply changing
to a dierent bulb manufacturer may solve the problem.
(3) Additionally, we do not recommend the use of fluorescent, CFL, or
LED loads without a neutral wire connected to the dimmer due to the
capacitive nature of these load types.
Warnings and Considerations
WARNING! Turn OFF electrical power before installing or servicing this
product. Improper use or installation can cause SERIOUS INJURY, DEATH
or LOSS/DAMAGE OF PROPERTY.
ATTENTION! Coupez l’alimentation électrique avant d’installer ou de
réparer ce produit. Une mauvaise installation ou utilisation peut entraîner
des blessures graves, décès ou perte / dommages à la propriété.
WARNING! This device must be protected by a circuit breaker (20A max).
ATTENTION! Cet appareil doit être protégé par un disjoncteur (20A max.)
WARNING! Ground this device in accordance with the National Electric
Code (NEC) requirements. DO NOT rely solely upon the yoke plate’s
contact with a metal wallbox for adequate grounding. Use the device’s
ground wire to make a secure connection to the safety ground of the
electrical system.
ATTENTION! Cet appareil doit être en conformité avec le Code national
de l’électricité (NEC). Ne comptez pas uniquement au contact de la
plaque avant avec un boîtier mural métallique pour la mise à la terre
adéquate. Utilisez cet appareil à la terre de l’appareil pour établir une
connexion sécurisée au système électrique.
IMPORTANT! This device must be installed by a licensed electrician in
accordance with all national and local electrical codes.
IMPORTANT! If you are unsure about any part of these instructions,
consult a qualified electrician.
Supported Model
đŏ C4-FPD120 Forward Phase Dimmer
Introduction
The Control4® Forward Phase Dimmer operates independently or as part of a
Control4 home automation system. It installs in a standard wall box using typical
wiring standards and communicates to the Control4 system using a wireless
connection.
Box Contents
đŏ Forward Phase Dimmer
đŏ Wire Nuts
đŏ Warranty Card
đŏ +.3. ŏ$/!ŏ%))!.ŏ*/0((0%+*ŏ1% ! (this document)
Specifications and Supported Load Types
The specifications are described below.
Model Number C4-FPD120-xx
Power Requirements 120 VAC +/-10%, 50/60 Hz
This device can function with or without a
neutral AC connection depending on load type.
See load types and wiring diagrams below.
When wired without a neutral, loads may
appear dimmer.
Power Consumption 450mW
Load Types and Ratings
Supported Load Types Incandescent; Halogen; Magnetic (Iron Core,
Inductive) Low Voltage (MLV) transformers;
Forward Phase Dimmable Fluorescents,
Compact Fluorescents, and LEDs.
Maximum Load 1 Gang 2 Gang 3+ Gang
Incandescent (Tungsten) 1000W 800W 600W
Halogen 1000W 800W 600W
Fluorescent* 500W 500W 500W
Compact Fluorescent (CFL)* 500W 500W 500W
LED* 200W 200W 200W
Minimum Load (with neutral)
Incandescent (Tungsten) 4.5W
Halogen 4.5W
Fluorescent* 4.5W
Compact Fluorescent (CFL)* 4.5W
LED* 4.5W
Forward Phase
Dimmer
Installation Guide

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Control 4 C4-FPD120 and is the answer not in the manual?

Control 4 C4-FPD120 Specifications

General IconGeneral
BrandControl 4
ModelC4-FPD120
CategoryDimmer
LanguageEnglish

Related product manuals