Control 4 CCZ-T1-W - Box Contents; Requirements

Box Contents
• Wireless Thermostat
• CR123A (3V) battery
• 3 screws (#6 x 1-inch sheet metal screws)
• 3 plastic wall anchors (#4-6 x 7/8”)
• Warranty card
• U-shaped terminal jumper wire
Requirements
• Pencil (#2 or darker)
• Drill with 3/16” drill bit
• Small level (optional)
• Small flat-blade screwdriver
• Phillips screwdriver
• Tape for labeling wires
• Power-stealing bypass resistor (270 Ohm)
• Control4WirelessThermostatInstallationGuide (this document)
2