Controls MVP-350 - CAN Configuration; Maintenance Configuration; Emissions Configuration; Clutch Configuration

CONTROLS, INCORPORATED
C O N T R O L S Y S T E M S & S O L U T I O N S
- 13 -
(8)
CAN Configuration
Engine Manufacturer
TSC1 Address (Default = 3) Others available
Source Address (Default = 44) Others available
Engine Address (Default = 0) Others available
Fuel Level Transmit On/Off
Voltage Transmit On/Off
Hours Transmit On/Off
Engine Status Transmit
Panel Status Transmit On/Off
Panel Information Transmit On/Off
Faults Transmit
JDLINK Auto Accept
(9)
Maintenance Configuration
Service Messages
Schedule Selection
Schedule Reset
Schedule Interval
Schedule Warning
Schedule Trip
Schedule Message
(10)
Emissions Configuration
DEF Level Check (Default = Off)
Low DEF Pre Alarm (Default = 16%)
Low DEF Alarm (Default = 0%)
DEF Alarm Delay
Allow Service Regeneration Yes/No (Deere Only)
Regeneration Interlock On/Off
TSC Transmit Yes/No (stop TSC to engine during regeneration)
DPF Inhibit Lamp Source
(11)
Clutch Configuration
Clutch #1 Engage Trip (Default = None)
Clutch #1 Engage Speed (Default = 800 rpm)
Clutch #1 Engage Load (Default = 0%)
Clutch #1 Engage Coolant Temperature (Default = 150°F)
Clutch #1 Engage Delay (Default = 0:00)
Clutch #1 Engage Interval (Default = 0:00)
Clutch #1 Release Trip (Default = None)
Clutch #1 Release Speed (Default = 800 rpm)
Clutch #1 Release Load (Default = 0%)
Clutch #1 Release Coolant Temperature (Default = 150°F)
Clutch #1 Release Delay (Default = 0:00)
Clutch #1 Release Interval (Default = 0:00)