To Next PageTo Next Page
Need help?Do you have a question about the Controls MVP-350 and is the answer not in the manual?
General| Model | MVP-350 |
|---|---|
| Category | Controller |
| Manufacturer | Controls |
| Input Voltage | 24 VDC |
| Display | LCD |
| Type | Programmable Logic Controller (PLC) |
| Communication Protocol | Ethernet |
Settings for manual and automatic throttle operation.
Details on Vernier, Multistate, and High/Low throttle types.
ECU actions for safety, alarms, and fault codes.
How the panel displays and reads engine trouble codes.
Details on Pre Alarm, Throttle Up, and Throttle Down functions.
Explains Off/Always/Run and Alarm Delay settings for digital functions.
Instructions for entering, exiting, and scrolling through menus.
Steps to modify parameters and make selections within the menu.
Lists menus for accessing engine and emissions data.
Password-protected menus for system setup.
Initial controller setup options.
Setup for engine parameters like fuel level and voltage.
Configuring digital and analog inputs.
Configuring digital and relay outputs.
Settings for throttle type, mode, and speed.
Settings for power modes and delays.
Options for display units and performance display.
Settings for J1939 CAN bus communication.
Configuration for service messages and schedules.
Settings for DEF level and regeneration.
Settings for clutch engagement and release parameters.
