888-Convaid (266-8243)
39
Cruiser 12
INSTRUCTIONS
Brake Assy for Rolko Wheel - Right
1. Remove rear wheel from the frame.
2. Using two 5/8” wrenches, remove the axle nut and axle.
3. Use a 7/16” wrench and a 5/32” allen wrench to remove existing brake assembly from
the frame.
4. Install the new brake assembly. Be sure to follow the schematic to place the washers
in the proper order.
5. Before attaching the nuts onto the bolt, apply some loctite Item 14 onto the threads
of the nut.
6. Use a 7/16” wrench and a 5/32” allen wrench to tighten the nuts and bolts.
7. Make sure not to over tighten the nuts of the Brake Lever. The Brake Lever should be
allowed to rotate with minimal resistance.
8. Use two 5/8” wrenches to reattach the axle onto the frame.
To Next Page
Loading...
