Convaid Cruiser 12 - Page 83

888-Convaid (266-8243)
79
Cruiser 12
INSTRUCTIONS
1. Attach the Lateral Trunk Support to the chair by wrapping the two rear straps around
the back of the chair and securing with Velcro
®
.
2. Attach the single ap, by wrapping the strap on the left ap around the side tubing of
the frame, and securing with Velcro
®
(repeat steps on opposite side)
3. Thread the scoliosis strap through the plastic loop on the left ap, back through the
plastic loop on the opposite end of the strap, and pull tight.
4. Bring the scoliosis strap across the chest, thread it through the plastic loop on
opposite ap, and fasten with Velcro
®
.
• To support the right side of the trunk, attach the support to the chair with the double-
sided Velcro
®
strap on the left side. Detach the strap on the right ap from the tubing,
and tighten scoliosis strap until desired trunk positioning is obtained.
• To support the left side of the trunk, attach the support to the chair with the double-
sided Velcro
®
strap on the right side. Detach the strap on the left ap from the tubing,
and tighten scoliosis strap until desired trunk positioning is obtained.
Soft Adjustable Lateral Support - Single Flap
The Double Flap Lateral Trunk Support brings the trunk to midline position.
• The Inner aps mobilize the trunk.
• The Outer aps centralize the trunk and keep the arms in the front of the chair.
• The Scoli strap aligns the spine.
1. Attach the Lateral Trunk Support to the chair by wrapping the two rear straps around
the back of the chair and securing with Velcro
®
.
2. To attach the double ap, wrap the strap on the left-hand outer ap around the side
tubing of the frame and secure with Velcro
®
.
3. Thread the strap on the left-hand inner ap into the plastic loop on the outer ap
working from front to back.
4. Adjust and secure strap. (Repeat steps 3 and 4 on right-hand ap.)
5. Bring the long scoliosis strap through the plastic loop on the inner ap on the right-
hand side and across the chest.
6. Thread the strap through the plastic loop on the inner ap on the left-hand side.
7. Fasten the strap with Velcro
®
.
8. If additional tightness is desired, pull the scoliosis strap further and Velcro
®
it beyond
the inner ap.
9. Attaching Lateral Trunk Support Double Flap
Note: The Lateral Trunk Support - Double Flap can be used to support either the
left or right side of the trunk.
Soft Adjustable Lateral Support - Double Flap