Convaid Cruiser 12

To Next Page

To Previous Page

888-Convaid (266-8243)

Cruiser 12

INSTRUCTIONS

One Piece Height Adjustable Push Handle with Attendant

Handbrake

1. Remove Cable from Lever by pulling the cable away from the lever & routing

the inner cable off the level

2. Using a phillips screwdriver and a 3/8” wrench, remove the screw attaching the

handle tube assembly from the Cruiser Back Tubes.

3. Slide existing handle assembly off.

4. Slide new handle assembly onto the back tube. Item 1

5. Align the holes on the plastic pivot joint of the handle tube assembly with the

holes of the back tubes.

6. Insert new screw Item 3 into pivot joint.

7. Attach the nut Item 2 and tighten using a phillips screwdriver and a 3/8”

wrench. Attached cable onto the lever on the new handle.

Convaid Cruiser 12 - Page 9