Convotherm ConvoVent 4+ - Page 45




6 Moving and setting up the appliance
ConvoVent 4 / ConvoVent 4+ 45
Fitting the hood (ConvoVent 4 and ConvoVent 4+)
1.
For 6.10 and 6.20:
Undo the left-hand rear screw on the top cover of the appliance.
2. Pull the ground cable off the spade terminal on the ventilation
port.
3..
Use a 7mm socket wrench to undo the hose-clip screw on the
ventilation port until the hose clip can be pulled over the spade
terminal.
4.
For 6.10 and 6.20:
In the region of the ventilation port, lift up the top cover of the
appliance slightly.