17
In more detail...
GB IE
Operation
> (Light on): Programmer in automatic position and programmed.
> No symbol lit, except the clock numbers means that a waiting time is
programmed.
Programmer functions:
> 24-hour display clock.
> Alarm (Maximum 23:59).
> Automatic programming (start and end of cooking).
> Semi-automatic cooking (only start or only end of cooking).
> The timer only works when the appliance is connected to the electricity
supply.
Electronic clock
> Immediately after connection (also after a power cut) three ashing digits
will appear on the panel.
> To enter the correct time press
symbol and at the same time one of
the buttons
or until the correct time is shown. There is a 5-second
acceptance delay during which no button should be touched.
> The speed that the marker changes will noticeably increase some
seconds after beginning to press the buttons
and .
Manual cooking (without using the programmer)
> To use the oven with the help of the programmer, the ashing "AUTO"
indication must be cancelled by pressing the button
.
> If the "AUTO" indicator is not ashing (which means that the oven is
programmed) the programming must be cancelled rst by pressing
and setting the marker to 0.
Automatic cooking
Start of cooking:
1. Programme the cooking time using
.
2. Press the buttons
or to select the cooking time.
3. Select the temperature and function required using the thermostat and
selector knobs.
End of cooking:
1. Programme the end of the cooking time using
.
2. Press the buttons
or to select the cooking time.
3. Select the temperature and function required using the thermostat and
selector knobs.
To Next Page
Loading...
Need help?
General
