17
In more detail...
GB IE
Care and maintenance
Care and maintenance
Damaged power cables should be replaced by a
competent person or qualied electrician.
For domestic use only.
Never place the induction hob directly into water.
Never place an empty pan on the hob as this will cause
an error message to appear on the control panel.
When a cooking zone has been on for a long time, the
surface remains hot for some time afterwards so do not
touch the ceramic surface.
Occasionally check that nothing is obstructing the air inlet
beneath the induction hob.
If the surface of the hob is cracked, disconnect from
power supply the appliance to avoid any possibility of
electric shocks.
Do not place rough or uneven vessels on the hob, as
they could damage the ceramic surface.
Avoid banging pots and pans down on the hob.
The ceramic surface is tough but not unbreakable.
OFF
Warning
Always switch off the electricity supply before
performing maintenance work. In the event of a fault,
contact an ofcial distributor or authorised dealer.
To Next Page
Loading...
Need help?
General
