Issue 2 26/11/2019 8
Programming a start and stop time (requires the clock to be set)
1. Press the SET button TWICE. The ‘timer on’ indicator will
flash.
2. Use the HOUR & MIN buttons to set the desired start time.
3. Press the SET button again and the ‘timer off’ indicator will
flash.
4. Use the MIN button to set the desired switch off interval.
5. The set times will save automatically a few seconds after the
last press of a button and the indicators will stop flashing.
6. Fill the coffee maker with water and ground coffee and fit the
jug.
7. The display will dim and alternate between clock and the
programmed start time.
8. When the programmed start time is the same as the clock
the coffee maker will start to operate, a countdown timer (e.g.
fig.1) will be shown in the display and the coffee maker will
switch off after the set interval.
9. To cancel the start time, press the ON/OFF button once;
press the ON/OFF button twice again to clear the stop time
(the ‘timer on’ and ‘timer off’ indicators will clear from the
display respectively).
To Next Page
Loading...
