ISSUE-1 1/11/2017 5
Cleaning
To maximize the efficiency of the kettle, clean and descale regularly.
1. Switch off, unplug the kettle and allow it to cool completely.
2. Lift the lid and unclip the filter (fig 1 & 2).
3. Clean the filter under a running tap while gently brushing with a
soft nylon brush to remove the scale.
4. Descale with a proprietary descaler suitable for kettles and use in
accordance with the instructions on the pack. Alternatively half
fill the kettle with water and add the juice of one lemon. Boil the
kettle and allow it to stand for 15 minutes. Repeat this last step a
further two times before discarding the solution.
5. After descaling, fill the kettle to the maximum level, bring to the
boil and then discard the water.
6. Refit the filter (fig. 3). Support the filter with the fingers on the
inside the kettle and hook the clip at the bottom of the filter over
the lip on the lowest hole in the spout. Once the hook is in
position, press the top of the filter into the two upper holes.
7. Wipe external surfaces with a soft damp cloth; do not use
detergents or abrasives as these may scratch the surface.
Technical specification
Rated voltage 220-240V AC 50Hz
Power consumption 1850 - 2200W
Class rating I (Earthed)
BS 1362 fuse 13A
Capacity 1.7 litre
To Next Page
Loading...
