In the course of the design and the production of the blast chillers-freezers, particular attention was
paid to observance of the safety rules, which enable the user to use the equipment safely.
• In order to avoid accidental touching of live cables, the equipment is fitted with metal guards.
Such protections may be removed only by qualified personnel.
• In order to avoid accidental contact with moving parts, the blades of the fan on the condenser
and in the enclosure of the evaporator are covered with a protective grille.
• The electrical system complies with the CEI EN 60335-1:2002 standard.
As is the case with any electrical equipment, in order to avoid dangerous situations during installation
and during use, one must act in compliance with the applicable regulations.
• Before performing any maintenance, disconnect the equipment from the power supply network.
• Do not work with the equipment with wet hands or feet.
• Do not remove and do not tamper with protective devices while performing regular maintenance
work.
• Do not put any devices or kitchen tools into the cover of electrical and mechanical parts.
• Use appropriate and compatible equipment for maintenance.
• When not in use, the equipment should be switched off and the plug should be taken out of the
power socket.
Failure to observe the above rules may affect the safety of the equipment and of the user. The
manufacturer is not responsible for any changes to the original method of functioning of the equipment,
failure to observe the operating instructions, or changes to or installation of additional devices.
5. TECHNICAL DATA
In order to determine the technical characteristics of the blast chillers-freezers, it is recommended to
pay attention to the information contained in the data plate located on the back cover of the operating
manual.
A data plate is also provided in the back of the blast chiller and is intended for:
• identification of the product during the service based on its model, product number, and serial
number;
• providing information about the required electric power and supply voltage of the equipment;
• providing information about the type and quantity of the coolant.
•
To Next Page