Why Cool Space Air Conditioner fan will not reach full speed?
If the fan turns but doesn't reach full speed and makes a humming sound, check the capacitor and motor electrical connections, as well as the extension cord. Replacing the capacitor or motor, or increasing the cord gauge might solve the issue.
What to do if my Cool Space Air Conditioner motor keeps overheating?
If your Cool Space Air Conditioner motor overheats, shuts off, and restarts after a few minutes, it could be due to a small extension cord, obstructed inlet air, or a faulty motor. Try replacing the extension cord with a heavier gauge one, ensure there's at least 3 feet of clearance for the inlet air, or replace the motor.
Why is my Cool Space Air Conditioner overflowing or spitting water?
If your Cool Space Air Conditioner unit overflows or spits water, it may be due to a loose float valve hose, excessive water pressure, or a float valve not seating correctly. To fix this, try the following: * Tighten the hose connections and/or replace the hose washers. * Reduce water pressure by installing an inline reducer. * Check the float valve and replace the float orifice if needed.
Why is my Cool Space CS5-48 Air Conditioner spitting water?
If water is spitting from your Cool Space Air Conditioner, it could be due to a cracked or loose hose, or flooding of the pads. Try tightening the hose connections, replacing the hose and washer, or adjusting the water flow control valve.
Why Cool Space Air Conditioner fan blade doesn't turn and makes squealing sound?
If the fan blade doesn’t turn and the unit makes a squealing sound, the start capacitor might be leaking, the motor might be stalled, the fan belt could be loose or broken, or the fan pulley might be spinning on the shaft. Replace the capacitor or motor, tighten or replace the fan belt, or tighten the pulley set screw.
Why won’t my Cool Space Air Conditioner fan motor run, but the switch clicks?
If the fan motor won’t run and the switch makes a soft clicking sound, the switch is making good contact. Replace the switch.
How do I fix dry streaks in my Cool Space Air Conditioner pads?
If you notice too many dry streaks in the pads of your Cool Space Air Conditioner, the holes in the spray bar might be blocked, or the water flow needs adjustment. Remove the spray bar, remove the plug, and clean the tube and holes. Also, open the water flow control valve to increase water flow.
Why won't my Cool Space CS5-48 Air Conditioner fan motor run but the switch clicks?
If your Cool Space Air Conditioner fan motor won’t run and the switch makes a soft clicking sound, the switch is likely making good contact. Replace the switch.
Why does my Cool Space Air Conditioner fan motor hum but not run?
If your Cool Space Air Conditioner fan motor hums but doesn't run, the blade might be touching the shroud, or the motor could be stalled. Try re-centering the blade hub. If the motor still won't turn by hand, consider replacing it.
What to do if the pump motor on my Cool Space CS5-48 Air Conditioner won't start?
If the pump motor on your Cool Space Air Conditioner doesn't run when the switch is on, first ensure the fan starts. Check the breaker and cord plug-in. If the fan starts, check for power to and through the pump switch when turned on. Also, make sure the water reservoir is full.
Connects the unit to a standard garden hose outlet. Ensure pressure is under 60 psi.
Plugs into a fused 20 amp, 120 volt, 60 Hz circuit. GFCI protected circuit recommended.
Turn water supply valve on; unit fills. Float valve shuts off flow when sump is full.
Turn fan switch HIGH, then set to Medium or Low. Keep pads moist.
Turn pump switch ON when sump is full. Adjust flow control knob for water volume to pads.
Remove two bolts to detach pad retainer, then tilt and lift pads out.
Shut off pump 15 mins before fan to drain and dry pads for pad life and mildew control.
Drain sump, clean reservoir, check belt, clean spray bar. Frequency depends on usage.
Remove pads, clean them. Drain and dry sump. Store unit in a dry area, covered.
Understand system dependencies to identify problems. Basic tools and a meter are needed.
Repairs must be done by qualified technicians. Disconnect power before servicing.
Contact distributor or use the Technical Support Hot Line at 1-800-557-5716 for assistance.
Fill out and return the warranty form supplied with the unit to the manufacturer.
Purchase replacement parts from your local Distributor or Supplier. Contact for questions.
Accessories are available from your local Distributor or Supplier. An order form is in the back.
Replacement Parts are available from your local Distributor or Supplier.
General| Brand | Cool Space |
|---|---|
| Model | CS5-48 Series |
| Category | Air Conditioner |
| Language | English |
To Next Page
