Why is my Cool Space Air Conditioner's drain valve leaking?
If water is leaking from the drain valve of your Cool Space Air Conditioner, it's likely due to a worn washer or stem. Ensure the drain valve is fully closed. Replace the washer or the entire drain valve to resolve this.
What to do if my Cool Space Air Conditioner motor keeps overheating?
If your Cool Space Air Conditioner motor overheats, shuts off, and restarts after a few minutes, it could be due to a small extension cord, obstructed inlet air, or a faulty motor. Try replacing the extension cord with a heavier gauge one, ensure there's at least 3 feet of clearance for the inlet air, or replace the motor.
Why is my Cool Space CS6-36 Air Conditioner overflowing or spitting water?
If your Cool Space Air Conditioner unit overflows or spits water, it may be due to a loose float valve hose, excessive water pressure, or a float valve not seating correctly. To fix this, try the following: * Tighten the hose connections and/or replace the hose washers. * Reduce water pressure by installing an inline reducer. * Check the float valve and replace the float orifice if needed.
Why is my Cool Space CS6-36 Air Conditioner spitting water?
If water is spitting from your Cool Space Air Conditioner, it could be due to a cracked or loose hose, or flooding of the pads. Try tightening the hose connections, replacing the hose and washer, or adjusting the water flow control valve.
Why is my Cool Space CS6-36 Air Conditioner pump so loud?
If your Cool Space Air Conditioner pump makes a loud noise while running, there might be objects in the impeller, a loose impeller, or bad pump bearings. Remove any obstructions. If the noise persists, replace the pump.
Why won't my Cool Space CS6-36 Air Conditioner pump run when power is on?
If your Cool Space Air Conditioner pump won’t run even with power available and the pump being functional, ensure the switch is working correctly. Also, check if the water level is high enough to complete the low-water cut-off circuit. Replace the switch if it's not completing the circuit, and fill the water reservoir.
Why is the floor wet next to my Cool Space CS6-36 Air Conditioner?
If the floor beside your Cool Space Air Conditioner unit is wet, the water inlet hose may be loose at the supply hose or bulkhead fitting. Tighten the connections and/or replace the hose washers.
Why don't the fan belts on my Cool Space Air Conditioner last long?
If the fan belts on your Cool Space Air Conditioner don't last very long, the motor and fan pulleys might be misaligned. Realign the motor and mount to correct this.
What to do if my Cool Space CS6-36 Air Conditioner fan blade won't turn and it's squealing?
If the fan blade on your Cool Space Air Conditioner doesn't turn and the unit makes a squealing sound, it could be due to several reasons: * A leaking start capacitor. * A motor stall. * A loose or broken fan belt. * A fan pulley spinning on the shaft. Replace the capacitor or motor, tighten or replace the fan belt, or tighten the pulley set screw.
Why does my Cool Space CS6-36 Air Conditioner fan motor hum but not run?
If your Cool Space Air Conditioner fan motor hums but doesn't run, the blade might be touching the shroud, or the motor could be stalled. Try re-centering the blade hub. If the motor still won't turn by hand, consider replacing it.
Provides instructions for carefully examining and opening the unit's packaging.
Details how to connect the unit to a water source using a garden hose connection.
Specifies requirements for connecting the unit to a fused or circuit breaker protected 20 amp, 120 volt, 60 Hz circuit.
Instructions for filling the unit with water and how the float valve operates.
Guidance on how to start the fan, including initial speed settings.
Steps for turning on the pump and adjusting water flow to cooling pads.
Procedure for removing cooling pads to gain access to internal unit components.
Recommendations for daily shutdown procedures to ensure pad life and prevent growth.
Routine maintenance procedures, including draining the sump and cleaning.
Instructions for preparing the unit for storage, including cleaning and dry storage.
General guidance on identifying and diagnosing problems within the unit's systems.
Detailed steps for repairing common issues like fan motor and pump replacement.
Information on how to fill out and return the warranty form.
Details on obtaining replacement warranty parts and returning faulty parts.
Information on available optional accessories for the units.
A list of common replacement parts for fan motors, switches, pumps, and pads.
Wiring diagram for specific COOL-SPACE models CS5-16-2D and CS5-48-2D.
Wiring diagram for specific COOL-SPACE models CS5-36-1D and CS6-36-1D.
Wiring diagram for specific COOL-SPACE models CS5-36-3B and CS6-36-3B.
Wiring diagram for specific COOL-SPACE models CS5-16-VD, CS5-36-VD, and CS6-36-VD.
General| Brand | Cool Space |
|---|---|
| Model | CS6-36 Series |
| Category | Air Conditioner |
| Language | English |
To Next Page
