Owner’s Manual
Page - 18 - of 22
6. With a soft nylon brush and garden hose with spray nozzle, wash down the HMX removing all dirt, debris and mineral build
up.
7. Inspect and clean the fan and other components with a dry rag or damp cloth avoiding contact with any electrical elements.
8. Wash out the bottom of the cabinet with a hose, ensuring the inlet drain holes are draining freely.
9. Reconnect all water supply tubing to HMX nipples and header.
10. Ensure the bottle is full of liquid dish soap.
11. Install new, clean air filters.
12. Reattach inlet plenum.
13. Reattach filter access door by sliding it on and then turning the handles clockwise or reattach the two (2) 5/16” (8 mm)
nuts.
14. Remove surfactant pump and control card access covers.
To Next Page
Loading...