- 11
-
Handbook
6 Installation Guide
6.1
Before Installation
To make sure the air-conditioner performs successfully, please follow the instruction：
1. To avoid overflow of condensed water, please make sure that the air conditioner keeps
upright during the installation, and make the inclination angle no more than 3 degrees.
2. Please move it gently and do not bump it in case the surface is scratched.
3. Please check the air conditioner after unpacking. If there is any part being damaged or
deformed, please contact local maintenance personnel.
4. Please check the accessories by list, and prepare the instal
lation tools.
5. Please make sure there is at least a 50cm clearance between any obstruction and the
condenser air inlet and outlet to avoid a return air short circuit.
6. The installation must be fulfilled by professionals according to this guide.
7. Please check the drainage to avoid drain blocking during installation.
8. Please support the external hanging cabinet during its transportation.
9. To contribute to the environmentally friendly community, please recycle the packaging.
6.2 Installation instruction
1.
Check the air conditioner and make sure it can function well. See more from page 3.
2.
Prepare the cabinet according to the dimension drawing from this handbook.
3.
Please do not damage the gasket during installation, and do not drag the air
conditioner on the cabinet. The gasket is used to seal the gap between the air
conditioner and cabinet, being damaged can cause waterproof failure.
4.
Please connect the power cord to a well-grounded power source according to the
nameplate on the machine. Circuits should be fitted with slow-blow fuses or HACR
circuit breakers.
To Next Page