Revised: 01/09/2016 13/02/17
2
WARNING
THE FOLLOWING INSTRUCTIONS MUST BE CARRIED OUT
OR WARRANTY BECOMES VOID.
Heater must be installed by a Coonara authorised technician. List is
available on www.shamic.com You must obtain a license number from
the installer.
Heater must be placed on a flat level surface. Inbuilt models must be
placed on 6mm AC sheeting, to prevent unit from rattling.
Heater must be checked for scratches or dents prior to installation.
All glass must be fitted with a screw driver not a drill. If glass is
broken upon installation due to the screws being tightened too much, it
will not be classed under warranty.
Further safety precautions and installation instructions are contained
throughout this manual. Please read the manual before installation.
To Next Page
Loading...